Autonomous: Reset Cisco Access Point to Factory Defaults Using the MODE Button

 

How to reset a Cisco AP using the MODE button.

I have a small project coming up and getting refreshed with the Cisco Autonomous Access Points...

Using the MODE Button

Follow these steps to delete the current configuration and return all access point settings to the factory defaults by using the MODE button:

1. Disconnect power from the access point (the power jack for external power or the Ethernet cable for in-line power).

2. Press and hold the MODE button while you reconnect power to the access point.

3. Continue pressing the MODE button until the Ethernet LED turns amber. (approximately 2 to 3 seconds). Then release the button.

4. After the access point reboots, you must reconfigure it using the web browser interface, the Telnet interface, or the access point console port.